The Mastery of the Air Part 7

In the general design and beauty of workmans.h.i.+p involved in the construction of aeroplanes, Britain is now quite the equal of her foreign rivals; even in engines we are making extremely rapid progress, and the well-known Green Engine Company, profiting by the result of nine years' experience, are able to turn out aeroplane engines as reliable, efficient, and as light in pounds weight per horse-power as any aero engine in existence.

In the early days of aviation larger and better engines of British make specially suited for aeroplanes were our most urgent need.

The story of the invention of the "Green" engine is a record of triumph over great difficulties.

Early in 1909--the memorable year when M. Bleriot was firing the enthusiasm of most engineers by his cross-Channel flight; when records were being established at Rheims; and when M. Paulhan won the great prize of L10,000 for the London to Manchester flight--Mr. Green conceived a number of ingenious ideas for an aero engine.

One of Mr. Green's requirements was that the cylinders should be made of cast-steel, and that they should come from a British foundry. The company that took the work in hand, the Aster Company, had confidence in the inventor's ideas. It is said that they had to waste 250 castings before six perfect cylinders were produced. It is estimated that the first Green engine cost L6000. These engines can be purchased for less than L500.

The closing months of 1909 saw the Green engine firmly established.

In October of that year Mr. Moore Brabazon won the first all-British compet.i.tion of L1000 offered by the Daily Mail for the first machine to fly a circular mile course. His aeroplane was fitted with a 60-horse-power Green aero engine. In the same year M. Michelin offered L1000 for a long-distance flight in all-British aviation; this prize was also won by Mr. Brabazon, who made a flight of 17 miles.

Some of Colonel Cody's achievements in aviation were made with the Green engine. In 1910 he succeeded in winning both the duration and cross-country Michelin compet.i.tions, and in 1911 he again accomplished similar feats. In this year he also finished fourth in the all-round-Britain race. This was a most meritorious performance when it is remembered that his Cathedral weighed nearly a ton and a half, and that the 60-horse-power Green was practically "untouched", to use an engineering expression, during the whole of the 1010-mile flight.

The following year saw Cody winning another Michelin prize for a cross-country compet.i.tion. Here he made a flight of over 200 miles, and his high opinion of the engine may be best described in the letter he wrote to the company, saying: "If you kept the engine supplied from without with petrol and oil, what was within would carry you through".

But the pinnacle of Mr. Green's fame as an inventor was reached in 1913, when Mr. Harry Hawker made his memorable waterplane flight from Cowes to Lough s.h.i.+nny, an account of which appears in a later chapter. His machine was fitted with a 100-horse-power Green, and with it he flew 1043 miles of the 1540-miles course.

Though the complete course was not covered, neither Mr. Sopwith--who built the machine and bore the expenses of the flight--nor Mr. Hawker attached any blame to the engine. At a dinner of the Aero Club, given in 1914, Mr. Sopwith was most enthusiastic in discussing the merits of the "Green", and after Harry Hawker had recovered from the effects of his fall in Lough s.h.i.+nny he remarked in reference to the engine: "It is the best I have ever met. I do not know any other that would have done anything like the work."

At the same time that this race was being held the French had a compet.i.tion from Paris to Deauville, a distance of about 160 miles. When compared with the time and distance covered by Mr. Hawker, the results achieved by the French pilots, flying machines fitted with French engines, were quite insignificant; thus proving how the British industry had caught up, and even pa.s.sed, its closest rivals.

In 1913 Mr. Grahame White, with one of the 100-horse-power "Greens"

succeeded in winning the duration Michelin with a flight of over 300 miles, carrying a mechanic and pilot, 85 gallons of petrol, and 12 gallons of lubricating oil. Compulsory landings were made every 63 miles, and the engine was stopped. In spite of these trying conditions, the engine ran, from start to finish, nearly nine hours without the slightest trouble.

Sufficient has been said to prove conclusively that the thought and labour expended in the perfecting of the Green engine have not been fruitless.

CHAPTER XXIV. The Wright Biplane (Camber of Planes)

Now that the internal-combustion engine had arrived, the Wrights at once commenced the construction of an aeroplane which could be driven by mechanical power. Hitherto, as we have seen, they had made numerous tests with motorless gliders; but though these tests gave them much valuable information concerning the best methods of keeping their craft on an even keel while in the air, they could never hope to make much progress in practical flight until they adopted motor power which would propel the machine through the air.

We may a.s.sume that the two brothers had closely studied the engines patented by Daimler and Leva.s.sor, and, being of a mechanical turn of mind themselves, they were able to build their own motor, with which they could make experiments in power-driven flight.

Before we study the gradual progress of these experiments it would be well to describe the Wright biplane. The ill.u.s.tration facing p. 96 shows a typical biplane, and though there are certain modifications in most modern machines, the principles upon which it was built apply to all aeroplanes.

The two main supporting planes, A, B, are made of canvas stretched tightly across a light frame, and are slightly curved, or arched, from front to back. This curve is technically known as the CAMBER, and upon the camber depend the strength and speed of the machine.

If you turn back to Chapter XVII you will see that the plane is modelled after the wing of a bird. It has been found that the lifting power of a plane gradually dwindles from the front edge--or ENTERING EDGE, as it is called--backwards. For this reason it is necessary to equip a machine with a very long, narrow plane, rather than with a comparatively broad but short plane.

Perhaps a little example will make this clear. Suppose we had two machines, one of which was fitted with planes 144 feet long and 1 foot wide, and the other with planes 12 feet square. In the former the entering edge of the plane would be twelve times as great as in the latter, and the lifting power would necessarily be much greater. Thus, though both machines have planes of the same area, each plane having a surface of 144 square feet, yet there is a great difference in the "lift" of the two.

But it is not to be concluded that the back portion of a plane is altogether wasted. Numerous experiments have taught aeroplane constructors that if the plane were slightly curved from front to back the rear portion of the plane also exercised a "lift"; thus, instead of the air being simply cut by the entering edge of the plane, it is driven against the arched back of the plane, and helps to lift the machine into the air, and support it when in flight.

There is also a secondary lifting impulse derived from this simple curve. We have seen that the air which has been cut by the front edge of the plane pushes up from below, and is arrested by the top of the arch, but the downward dip of the rear portion of the plane is of service in actually DRAWING THE AIR FROM ABOVE. The rapid air stream which has been cut by the entering edge pa.s.ses above the top of the curve, and "sucks up", as it were, so that the whole wing is pulled upwards. Thus there are two lifting impulses: one pus.h.i.+ng up from below, the other sucking up from above.

It naturally follows that when the camber is very p.r.o.nounced the machine will fly much slower, but will bear a greater weight than a machine equipped with planes having little or no camber. On high-speed machines, which are used chiefly for racing purposes, the planes have very little camber. This was particularly noticeable in the monoplane piloted by Mr.

Hamel in the Aerial Derby of 1913: the wings of this machine seemed to be quite flat, and it was chiefly because of this that the pilot was able to maintain such marvellous speed.

The scientific study of the wing lift of planes has proceeded so far that the actual "lift" can now be measured, providing the speed of the machine is known, together with the superficial area of the planes. The designer can calculate what weight each square foot of the planes will support in the air. Thus some machines have a "lift" of 9 or 10 pounds to each square foot of wing surface, while others are reduced to 3 or 4 pounds per square foot.

CHAPTER XXV. The Wright Biplane (Cont.)

The under part of the frame of the Wright biplane, technically known as the CHa.s.sIS, resembled a pair of long "runner" skates, similar to those used in the Fens for skating races. Upon those runners the machine moved along the ground when starting to fly. In more modern machines the cha.s.sis is equipped with two or more small rubber-tyred wheels on which the machine runs along the ground before rising into the air, and on which it alights when a descent is made.

You will notice that the pilot's seat is fixed on the lower plane, and almost in the centre of it, while close by the engine is mounted.

Alongside the engine is a radiator which cools the water that has pa.s.sed round the cylinder of the engine in order to prevent them from becoming overheated.

Above the lower plane is a similar plane arranged parallel to it, and the two are connected by light upright posts of hickory wood known as STRUTS. Such an aeroplane as this, which is equipped with two main planes, known as a BIPLANE. Other types of air-craft are the MONOPLANE, possessing one main plane, and the TRIPLANE, consisting of three planes.

No practical machine has been built with more than three main planes; indeed, the triplane is now almost obsolete.

The Wrights fitted their machine with two long-bladed wooden screws, or propellers, which by means of chains and sprocket-wheels, very like those of a bicycle, were driven by the engine, whose speed was about 1200 revolutions a minute. The first motor engine used by these clever pioneers had four cylinders, and developed about 20 horsepower. Nowadays engines are produced which develop more than five times that power.

In later machines one propeller is generally thought to be sufficient; in fact many constructors believe that there is danger in a two-propeller machine, for if one propeller got broken, the other propeller, working at full speed, would probably overturn the machine before the pilot could cut off his engine.

Beyond the propellers there are two little vertical planes which can be moved to one side or the other by a control lever in front of the pilot's seat. These planes or rudders steer the machine from side to side, answering the same purpose as the rudder of a boat.

In front of the supporting planes there are two other horizontal planes, arranged one above the other; these are much smaller than the main planes, and are known as the ELEVATORS. Their function is to raise or lower the machine by catching the air at different angles.

Comparison with a modern biplane, such as may be seen at an aerodrome on any "exhibition" day, will disclose several marked differences in construction between the modern type and the earlier Wright machine, though the central idea is the same.

CHAPTER XXVI. How the Wrights launched their Biplane

Those of us who have seen an aeroplane rise from the ground know that it runs quickly along for 50 or 60 yards, until sufficient momentum has been gained for the craft to lift itself into the air. The Wrights, as stated, fitted their machine with a pair of launching runners which projected from the under side of the lower plane like two very long skates, and the method of launching their craft was quite different from that followed nowadays.

The launching apparatus consisted of a wooden tower at the starting end of the launching ways--a wooden rail about 60 or 70 feet in length.

To the top of the tower a weight of about 1/2 ton was suspended. The suspension rope was led downwards over pulleys, thence horizontally to the front end and back to the inner end of the railway, where it was attached to the aeroplane. A small trolley was fitted to the cha.s.sis of the machine and this ran along the railway.

To launch the machine, which, of course, stood on the rail, the propellers were set in motion, and the 1/2-ton weight at the top of the tower was released. The falling weight towed the aeroplane rapidly forward along the rail, with a velocity sufficient to cause it to glide smoothly into the air at the other end of the launching ways. By an ingenious arrangement the trolley was left behind on the railway.

It will at once occur to you that there were disadvantages in this system of commencing a flight. One was that the launching apparatus was more or less a fixture. At any rate it could not be carried about from place to place very readily: Supposing the biplane could not return to its starting-point, and the pilot was forced to descend, say, 10 or 12 miles away: in such a case it would be necessary to tow the machine back to the launching ways, an obviously inconvenient arrangement, especially in unfavourable country.

For some time the "wheeled" cha.s.sis has been in universal use, but in a few cases it has been thought desirable to adopt a combination of runners and wheels. A moderately firm surface is necessary for the machine to run along the ground; if the ground be soft or marly the wheels would sink in the soil, and serious accidents have resulted from the sudden stoppage of the forward motion due to this cause.

With their first power-driven machine the Wrights made a series of very fine flights, at first in a straight line. In 1904 they effected their first turn. By the following year they had made such rapid progress that they were able to exceed a distance of 20 miles in one flight, and keep up in the air for over half an hour at a time. Their manager now gave their experiments great publicity, both in the American and European Press, and in 1908 the brothers, feeling quite sure of their success, emerged from a self-imposed obscurity, and astonished the world with some wonderful flights, both in America and on the French flying ground at Issy.

A great loss to aviation occurred on 30th May, 1912, when Wilbur Wright died from an attack of typhoid fever. His work is officially commemorated in Britain by an annual Premium Lecture, given under the auspices of the Aeronautical Society.

CHAPTER XXVII. The First Man to Fly in Europe

In November, 1906, nearly the whole civilized world was astonished to read that a rich young Brazilian aeronaut, residing in France, had actually succeeded in making a short flight, or, shall we say, an enormous "hop", in a heavier-than-air machine.