Two Thousand Miles on an Automobile Part 7

As there is supposed--erroneously--to be no moisture in the cylinder of a gas-engine, the use of any animal oil is said to be unnecessary; as there is moisture in the cylinder of a steam-engine, some animal oil is absolutely essential in the cylinder oil.

For the lubrication of chains and all parts exposed to the weather, compounds of oil or grease which contain a liberal amount of animal fat are better. Rain and the splash of mud and water will wash off mineral oil as fast as it can be applied; in fact, under adverse weather conditions it does not lubricate at all; the addition of animal fat makes the compound stick.

Graphite and mica are both good chain lubricants, but if mixed with a pure mineral base, such as vaseline, they will wash off in mud and water. Before putting on a chain, it is a good thing to dip it in melted tallow and then grease it thoroughly from time to time with a graphite compound of vaseline and animal fat.

One does not expect perfection in a machine, but there is not an automobile made, according to the reports of users, which does not develop many crudities and imperfections in construction which could be avoided by care and conscientious work in the factory, --crudities and imperfections which customers and users have complained of time and time again, but without avail.

At best the automobile is a complicated and difficult machine in the hands of the amateur, and so far it has been made almost impossible by its poor construction. With good construction there will be troubles enough in operation, but at the present time ninety per cent. of the stops and difficulties are due to defective construction.

As the machine comes it looks so well, it inspires unbounded confidence, but the first time it is seen in undress, with the carriage part off, the machinery laid bare, the heart sinks, and one's confidence oozes out.

Parts are twisted, bent, and hammered to get them into place, bearings are filed to make them fit, bolts and screws are weak and loose, nuts gone for the want of cotter-pins; it is as if apprentice blacksmiths had spent their idle moments in constructing a machine.

The carriage work is hopelessly bad. The building of carriages is a long-established industry, employing hundreds of thousands of hands and millions of capital, and yet in the entire United States there are scarcely a dozen builders of really fine, substantial, and durable vehicles. Yet every cross-road maker of automobiles thinks that if he can only get his motor to go, the carpenter next door can do his woodwork. The result is cheap stock springs, clips, irons, bodies, cus.h.i.+ons, tops, etc., are bought and put over the motor. The use of aluminum bodies and more metal work generally is helping things somewhat; not that aluminum and metal work are necessarily better than wood, but it prevents the unnatural union of the light wood bodies, designed for cheap horse-vehicles, with a motor. The best French makers do not build their bodies, but leave that part to skilled carriage builders.

CHAPTER SEVEN BUFFALO TO CANANDAIGUA BEWARE OF THE COUNTRY MECHANIC

The five hundred and sixty-odd miles to Buffalo had been covered with no trouble that delayed us for more than an hour, but our troubles were about to begin.

The Professor had still a few days to waste frivolously, so he said he would ride a little farther, possibly as far as Albany.

However, it was not our intention to hurry, but rather take it easily, stopping by the way, as the mood--or our friends--seized us.

It rained all the afternoon of Tuesday, about all night, and was raining steadily when we turned off Main Street into Genesee with Batavia thirty-eight miles straight away. We fully expected to reach there in time for luncheon; in fact, word had been sent ahead that we would "come in," like a circus, about twelve, and friends were on the lookout,--it was four o'clock when we reached town.

The road is good, gravel nearly every rod, but the steady rain had softened the surface to the depth of about two inches, and the water, sand, and gravel were splashed in showers and sheets by the wheels into and through every exposed part of the mechanism. Soon the explosions became irregular, and we found the cams operating the sparker literally plastered over with mud, so that the parts that should slide and work with great smoothness and rapidity would not operate at all. This happened about every four or five miles. This mechanism on this particular machine was so constructed and situated as to catch and hold mud, and the fine grit worked in, causing irregularities in the action. This trouble we could count upon as long as the road was wet; after noon, when the sun came out and the road began to dry, we had less trouble.

When about half-way to Batavia the spark began to show blue; the reserve set of dry batteries was put in use, but it gave no better results. Apparently there was either a short circuit, or the batteries were used up; the bad showing of the reserve set puzzled us; every connection was examined and tightened. The wiring of the carriage was so exposed to the weather that it was found completely saturated in places with oil and covered with mud. The rubber insulation had been badly disintegrated wherever oil had dropped on it. The wires were cleaned as thoroughly as possible and separated wherever the insulation seemed poor. The loss of current was probably at the sparking coil; the mud had so covered the end where the binding parts project as to practically join them by a wet connection. Cleaning this off and protecting the binding parts with insulating tape we managed to get on, the spark being by no means strong, and the reserve battery for some reason weak.

If we had had a small buzzer, such as is sold for a song at every electrical store, to say nothing of a pocket voltmeter, we would have discovered in a moment that the reserve battery contained one dead cell, the resistance of which made the other cells useless.

At Batavia we tested them out with an ordinary electric bell, discovering at once the dead cell.

After both batteries are so exhausted that the spark is weak, the current from both sets can be turned on at the same time in two ways; by linking the cells in multiples,--that is, side by side, or in series,--tandem.

The current from cells in multiples is increased in volume but not in force, and gives a fat spark; the current from cells in series is doubled in force and gives a long blue hot spark. Both sparks, if the cells are fresh, will burn the points, though giving much better explosions.

As the batteries weaken, first connect them in multiples, then, as they weaken still more, in series.

Always carry a roll of insulating tape, or on a pinch bicycle tire-tape will do very well. Wrap carefully every joint, and the binding-posts of the cells for the tape will hold as against vibration when the little binding-screws will not. In short, use the tape freely to insulate, protect, and support the wires and all connections.

If the machine is wired with light and poorly insulated wire, it is but a question of time when the wiring must be done over again.

When we pulled up in Batavia at an electrician's for repairs, the Professor was a sight--and also tired. The good man had floundered about in the mud until he was picturesquely covered. At the outset he was disposed to take all difficulties philosophically.

"I should regret exceedingly," he remarked at our first involuntary stop, "to return from this altogether extraordinary trip without seeing the automobile under adverse conditions. Our experiences in the sand were no fault of the machine; the responsibility rested with us for placing it in a predicament from which it could not extricate itself, and if, in the heat of the moment and the sand, I said anything derogatory to the faithful machine, I express my regrets. Now, it seems, I shall have the pleasure of observing some of the eccentricities of the horseless carriage. What seems to be the matter?" and the Professor peered vaguely underneath.

"Something wrong with the spark."

"Bless me! Can you fix it?"

"I think so. Now, if you will be good enough to turn that crank."

"With pleasure. What an extraordinary piece of mechanism.--"

"A little faster."

"The momentum--"

"A little faster."

"Very heavy fly-wheel--"

"Just a little faster."

"Friction--mechanics--overcome--"

"Now as hard as you can, Professor."

"Exercise, muscle, but hard work. The spark,--is it there? Whew!"

and the Professor stopped, exhausted.

It was the repet.i.tion of those experiences that sobered the Professor and led him to speak of his work at home, which he feared he was neglecting. At the last stop he stood in a pool of water and turned the crank without saying anything that would bear repet.i.tion.

While touring, look out for gla.s.s, nails, and the country mechanic,--of the three, the mechanic can do the largest amount of damage in a given time. His well-meant efforts may wreck you; his mistakes are sure to. The average mechanic along the route is a veritable bull in a china shop,--once inside your machine, and you are done for. He knows it all, and more too. He once lived next to a man who owned a naphtha launch; hence his expert knowledge; or he knew some one who was blown up by gasoline, therefore he is qualified. Look out for him; his look of intelligence is deception itself. His readiness with hammer and file means destruction; if he once gets at the machine, give it to him as a reward and a revenge for his misdirected energy, and save time by walking.

Even the men from the factory make sad mistakes; they may locate troubles, but in repairing they will forget, and leave off more things than the floor will hold.

At Batavia we put in new batteries, repacked the pump, covered the coil with patent leather, so that neither oil nor water could affect it, and put on a new chain. Without saying a word, the bright and too willing mechanic who was a.s.sisting, mainly by looking on, took the new chain into his shop and cut off a link. A wanton act done because he "thought the chain a little too long,"

and not discovered until the machine had been cramped together, every strut and reach shortened to get the chain in place; meanwhile the factory was being vigorously blamed for sending out chains too short. During it all the mechanic was discreetly silent, but the new link on the vise in the shop betrayed him after the harm was done.

The run from Batavia to Canandaigua was made over roads that are well-nigh perfect most of the way, but the machine was not working well, the chain being too short. Going up stiff grades it was very apparent something was wrong, for while the motor worked freely the carriage dragged.

On the level and down grade everything went smoothly, but at every up grade the friction and waste of power were apparent. Inspection time and again showed everything clear, and it was not until late in the afternoon the cause of the trouble was discovered. A tell-tale mark on the surface of the fly-wheel showed friction against something, and we found that while the wheel ran freely if we were out of the machine, with the load in, and especially on up grades with the chain drawing the framework closer to the running gear, the rim of the wheel just grazed a bolt-head in a small brace underneath, thereby producing the peculiar grating noise we had heard and materially checking the motor. The shortening of the struts and reaches to admit the short chain had done all this. As the chain had stretched a little, we were able to lengthen slightly the struts so as to give a little more clearance; it was also possible to s.h.i.+ft the brace about a quarter of an inch, and the machine once more ran freely under all conditions.

Within twenty miles of Canandaigua the country is quite rolling and many of the hills steep. Twice we were obliged to get out and let the machine mount the grades, which it did; but it was apparent that for the hills and mountains of New York the gearing was too high.

On hard roads in a level country high gearing is all well enough, and a high average speed can be maintained, but where the roads are soft or the country rolling, a high gear may mean a very material disadvantage in the long run.

It is of little use to be able to run thirty or forty miles on the level if at every grade or soft spot it is necessary to throw in the hill-climbing gear, thereby reducing the speed to from four to six miles per hour; the resulting average is low. A carriage that will take the hills and levels of New York at the uniform speed of fifteen miles an hour will finish far ahead of one that is compelled to use low gears at every grade, even though the latter easily makes thirty or forty miles on the level.

The machine we were using had but two sets of gears,--a slow and a fast. All intermediate speeds were obtained by throttling the engine. The engine was easily governed, and on the level any speed from the lowest to the maximum could be obtained without juggling with the clutches; but on bad roads and in hilly localities intermediate gears are required if one is to get the best results out of a motor. As the gasoline motor develops its highest efficiency when it is running at full speed, there should be enough intermediate gears so the maximum speed may be maintained under varying conditions. As the road gets heavy or the grades steep, the drop is made from one gear down to another; but at all times and under all conditions--if there are enough intermediate gears--the machine is being driven with the motor running fast.

With only two gears where roads or grades are such that the high gear cannot be used, there is nothing to do but drop to the low, --from thirty miles an hour to five or six,--and the engine runs as if it had no load at all. American roads especially demand intermediate gears if best results are to be attained, the conditions change so from mile to mile.

Foreign machines are equipped with from three to five speed-changing gears in addition to the spark control, and many also have throttles for governing the speed of the engine.