Motor Truck Logging Methods Part 5

When the truck comes to a stop on the incline, the chock blocks are released from the opposite side and the logs roll off of their own accord. In some instances a gill-poke has been used in connection with the unloading incline, the logs being sheared off as the truck moves ahead. Usually the logs roll off readily without the use of the gill-poke and if a load does stick it can be loosened with a cant-hook, so that the gill-poke really is unnecessary.

Unloading on public wharves or roads where no permanent incline can be used is accomplished by placing a portable wedge-shaped timber in front of the outside truck and trailer wheels and driving upon it.

[Ill.u.s.tration: Parbuckling a load of logs from the truck and trailer.]

In the most efficient way of unloading the usual brow-skid is placed a few inches below the log bunk and the logs are parbuckled from the truck and trailer, an ill.u.s.tration of which is shown above. The trucks are run on an incline so that one side is raised about four inches. A crotch-line consisting of two half-inch cables is attached to the brow-skid and pa.s.sed under the logs to a ring fastened to an inch cable.

The larger cable pa.s.ses thru a block located on a gin pole. A light yarding or a land clearing donkey furnishes the power to parbuckle the logs into the water. By this method the logs are lifted from the truck as they are rolled into the water with little danger of the top log dropping on the log bunk as is often the case when other methods are used, resulting in expensive repairs for broken springs or bearings.

TIME STUDIES

Time is a very important item in loading and unloading. Usually the most time is consumed in loading, for which reason any improvement that will reduce the time taken to load will greatly increase the efficiency of the operation. With the proper unloading devices, the truck may be unloaded in the time required to knock down the chock blocks.

The following table is a record kept for one day of the actual time taken by a truck at each step in the hauling of logs at one operation.

However, it is possible to give only arbitrary figures to fit the particular operation of which they are taken. No average figures can be given that fit all conditions.

DONKEY ENGINE DUMP AT MILL Time Time Unload- Time Arrive Loading Leave Down Arrive ing Leave Up Scale A.M.

7:15 10 Min. 7:25 20 Min. 7:45 25 Min. 8:10 20 Min. 2592 8:30 5 Min. 8:35 27 Min. 8:57 13 Min. 9:10 20 Min. 2092 9:30 12 Min. 9:42 21 Min. 10:03 7 Min. 10:10 20 Min. 1908 10:30 12 Min. 10:42 33 Min. 11:15 30 Min. 11:45 20 Min. 3074 P.M.

12:05 10 Min. 12:15 35 Min. 12:50 17 Min. 1:07 20 Min. 2542 1:27 15 Min. 1:42 18 Min. 2:00 27 Min. 2:27 20 Min. 1828 2:47 8 Min. 2:55 21 Min. 3:16 8 Min. 3:24 20 Min. 1689 3:44 11 Min. 3:55 23 Min. 4:18 9 Min. 4:27 20 Min. 2407 4:47 14 Min. 5:01 26 Min. 5:27 12 Min. 5:39 20 Min. 2558 ----- Total 20690

Length of haul 5.9 miles round trip.

Amount of gasoline, 15 gallons.

The above figures were taken several years ago when the facilities for unloading were slower than the present day methods, which accounts for the excessive length of time taken to unload.[8]

[8] The writer is indebted to Mr. George Gunn, Jr., for these figures.

The unloading of a truck is a time when a little care taken will save considerable expense for repairs. Such a method as the parbuckling system should be used by companies with sufficient stumpage to warrant the expense of the extra donkey, to prevent the top logs from dropping to the log bunks, thereby saving the cost of repairing broken springs and bearings.

CONCLUSION

At present, the possibilities for the use of the motor truck for logging are just beginning to be realized. What effect their use will have upon the future methods of logging remains to be seen. It is certain, however, that the advent of motor truck transportation will have a marked effect upon the science of forestry and will bring about a closer utilization of our timber resources.

The motor truck and the portable band mill seem likely to furnish a combination which will do away with the old wasteful circular mill because it supplies the cheapness and efficiency of railroad transportation and is applicable to small and scattered tracts and to stands of low-grade lumber. The fact that the portable band mill may be moved for a cut of a million feet a.s.sures adaptability. This is not only an industrial advance but also a silvicultural advance in that it affords the possibility of cuttings at frequent intervals without greatly adding to the cost.

A closer utilization of our present stands of timber may be practiced by the use of the motor truck. In the northwest, only the larger material is taken from the forest, leaving a large amount of good timber on the ground in the form of poles and piling and chunks too short to be made into saw lumber but from which high grade ties can be made. The truck, in connection with a band mill, will furnish a means of utilizing this present waste at a profit to the operator.

The motor truck will be a valuable aid in the working out of a sound national forest policy for the proper use of our timber resources so that the timber will be utilized to the greatest possible extent and at the same time methods taken to provide for the perpetuation of the forest for future generations. This suggests a way of opening the timber for the market on some of our national forests. Most of the government owned forests are situated in more or less rugged country back from the regular routes of travel. The timber on a great many of these forests is over-mature and should be cut but at this time it is inaccessible. The problem confronting the country is how to make it accessible.

The plan for opening these forests is to build permanent concrete or asphalt roads from the nearest commercial centers thru these tracts taking into consideration the aesthetic value of the location as well as the possibilities of logging the timber from them. The timber, then, is to be taken out, under some silvicultural system and under government supervision, by motor truck operators who build their own roads from the nearest concrete road to the timber to be cut. Under this system of management, the state and federal government pays a part of the expense of building the permanent road and the operator pays a small sum for the use of the road by being taxed additional stumpage.

The system of management has many advantages. In the first place, the mature timber will be logged, the older decadent material coming out first, in small bodies and at the same time care being taken to reproduce a new stand. The total area is divided so that as the timber is logged in rotation a continuous cutting will be a.s.sured. Due to the use of the trucks and on account of the timber being cut in rotation, the fire danger will be greatly lessened. In case a fire gets beyond control, the roads thru the forest make an excellent way to bring in men and supplies to fight the fire. In this way, a fire is readily accessible in a few hours where formerly it took perhaps several days to organize the fire fighting party and reach the scene of action. The concrete roads themselves make good fire lines. By means of the good roads, the forest is opened to campers and tourists each of whom pays a small sum as they enter the forest to help pay for the cost of building the roads and to provide funds for more extensive highways. In this way the forest is opened for the timber, the best methods of utilization and forest regeneration are practiced, fire hazard is reduced, and the area is opened as a recreational ground so that the greatest possible value is obtained from the tract.

A great many other uses of the motor truck for logging and scientific forest utilization are being recognized, as example, for transporting pulpwood, veneer stock, cordwood, rosin and turpentine, and other forest products. Suffice it to say that this method of transportation has found a place in the industry and is here to stay. Its value has been recognized beyond doubt and in the future will play an important part in the further development of this country.

BIBLIOGRAPHY

1916. Motor Truck Logging.

The Power Wagon. Sept. 15. Page 34. (Periodical).

1916. The Law of the Public Highway in Was.h.i.+ngton.

West Coast Lumberman. Sept. 15. Page 23. (Periodical).

1916. Motor Truck Logging Now Making Great Strides on the Pacific Coast. West Coast Lumberman. Nov. 1. Page 260. (Periodical).

1917. Motor Truck Logging in the Pacific Northwest.

West Coast Lumberman. Mar. 15. Page 70. (Periodical).

1917. Motor Trucks in High Favor Among Lumbermen.

Lumber World Review. Mar. 25. Page 23. (Periodical).

1917. Motor Truck Logging on Camano Island.

West Coast Lumberman. July 1. Page 28. (Periodical).

1917. Motor Truck Logging.

The Commercial Vehicle. Sept. 1. Page 12. (Periodical).

1918. Pole Roads. A. R. Hillard.

West Coast Lumberman. Feb. 1. Page 34. (Periodical).

1918. Operating Cost of Motor Trucks Computed. H. S. Finch.

Timberman. Feb. 1. Page 60. (Periodical).

1918. Winch for Motor Trucks.

American Lumberman. Mar. 2. Page 58. (Periodical).

1918. Motor Truck Roads.

American Lumberman. Mar. 16. Page 38. (Periodical).

1918. The Motor Truck in the Logging Industry. H. H. Warwood.

Timberman. April 1. Page 74. (Periodical).

1918. Road Construction for Motor Trucks. Jay C. Smith.

Timberman. April 1. Page 38. (Periodical).